The board shows a free driver. Whether that driver can legally take the load is a different question, and the planner is the first person who can get it wrong, long before a roadside check.
Regulation (EC) No 561/2006 caps how long a driver may drive, when a break is due and how much rest has to follow. The checks below cover a normal FTL day; national enforcement differs, so go to the regulation text for edge cases. Cabotage counts run on a clock of their own, covered in EU cabotage: 3-in-7 and the 4-day cooling-off.
The limits that decide most assignments
| Rule | Limit |
|---|---|
| Daily driving | 9 hours, extendable to 10 hours no more than twice in a week |
| Weekly driving | 56 hours |
| Driving in two consecutive weeks | 90 hours |
| Break | At least 45 minutes after 4.5 hours of driving, or 15 minutes followed by 30 minutes |
| Regular daily rest | At least 11 hours |
| Reduced daily rest | At least 9 hours, at most three times between two weekly rests |
| Split daily rest | 3 hours plus 9 hours (12 hours in total) |
| Regular weekly rest | At least 45 hours |
| Reduced weekly rest | At least 24 hours, compensated in one block before the end of the third week that follows |
Two rules come from the weekly rest and get forgotten on long international runs. A new weekly rest must start within six 24-hour periods of the end of the previous one. And a regular weekly rest of 45 hours or more cannot be taken in the cab; the employer pays for suitable accommodation. The Court of Justice noted in its 2024 Mobility Package judgment that this ban was not new.
Five questions before you assign
How much driving is left today? Count what the driver has already used, including driving before the shift you can see. A driver who has used 6 h 15 min has at most 3 h 45 min left, and only if a 10-hour day is still available this week.
Does the job fit, empty run included? The empty leg to the pickup counts as driving. Add the empty leg, the loaded leg and any repositioning, then compare the total with what is left. If it does not fit, the load needs a second driver, a rest in the middle or another truck.
Is a break due on the way? After 4.5 hours of driving the driver needs a break. A leg that starts with 3 hours already driven since the last break needs its 45 minutes after only 1.5 hours.
Where does the daily rest fall? If the load cannot be delivered within today's driving time, the driver rests at some point, and the pickup or delivery slot has to be judged after that rest. A reduced 9-hour rest is allowed up to three times between weekly rests, but a plan that relies on it has nothing left when the day goes wrong.
Where is the driver in the weekly cycle? Check the 56-hour week, the 90-hour fortnight and how close the driver is to the weekly rest deadline. This one is easy to miss because it does not show on today's view.
Does this load fit?
A driver has driven 6 h 15 min today and took the 45-minute break at 4 h 30 min, so 1 h 45 min of today's driving came after the break. A load is offered: a 2-hour empty run to the pickup, then a 4 h 30 min loaded leg, 6 h 30 min of driving in all.
Under the 9-hour limit the driver has 2 h 45 min left today, or 3 h 45 min if a 10-hour day is still available this week. The next break falls due after another 2 h 45 min of driving, exactly where the 9-hour day runs out; on a 10-hour day the driver stops there for 45 minutes and then has one hour left. Either way the 6 h 30 min job does not fit today. The planner can move the pickup to the next day after the daily rest, give the load to another driver, or agree a later delivery with the customer.
When the driver's hours are unknown
The check is only as good as the driver's real hours, which come from the tachograph through a telematics provider or from manual entry. A missing reading cannot be read as zero hours used, or the tool offers a driver who may be out of hours. Read as zero hours left, it blocks every load. So the figure has to show as unknown, and a planner has to check that driver another way.

On the Druma planning board a driver with no reading gets no hours warning, and the driver app shows a dash. Otherwise the board reads the hours from connected telematics and tacho providers, or from the driver app when a driver enters them by hand, and works out what the driver will have left at the pickup slot, so a driver who cannot make the slot today is judged after the daily rest. The weekly and fortnightly caps are applied to that figure, one hour or less shows in red, auto-plan counts thin hours as a cost when it ranks trucks, and the driver sees the same remaining hours in the app. A flagged assignment can still be made: the board warns and the planner decides. The Compliance page shows where each figure appears.

The fifth question is the one left to the planner. Druma's suggestions do not look at the deadline for starting the next weekly rest, so on a long rotation count the six 24-hour periods yourself before adding another load.
Sources
Facts last checked November 1, 2026
